找回密码
 立即注册
相关推荐换一批
  1. QC/T 995-2015 液压驱动模块运输车
  2. YD/T 1683-2007 CDMA 数字蜂窝移动通信网移动设备(ME)与用户识别模块(UIM)间接口测?
  3. GB/T 39075.202-2023普通照明用有机发光二极管(OLED)光源 安全 第2-2部分:特殊要
  4. YD/T 1294-2003 ATM 无源光网络(A-PON)光收发模块技术要求 —— 155Mb/s 突发式收发
  5. YD/T 1766-2008 光通信用光收发合一模块的可靠性实验失效判据
  6. YD/T 1688.4-2011 xPON 光收发合一模块技术条件 第4部分:用于 10G EPON 光线路终端/
  7. YD/T 1688.3-2011 xPON 光收发合一模块技术条件 第3部分:用于 GPON 光线路终端/光网
  8. YD/T 1351-2005 粗波分复用光收发合一模块技术要求和测试方法
  9. YD/T 1465-2006 10Gbit/s 小型化可插拔光收发合一模块技术条件
  10. GB/T 33558-2017 地面数字电视网络接口模块(NIM)技术要求和测量方法
  11. YD/T 1318-2004 1310/1550nm 短距离单纤双向组件(模块)技术条件
  12. YD/T 1321.2-2004 具有复用/去复用功能的光收发合一模块技术条件 第二部分: 10Gbit/
  13. YD/T 1321.1-2004 具有复用/去复用功能的光收发合一模块技术条件 第一部分: 2.5Gbit
  14. YD/T 1271-2003 通信设备用铃流信号发生器
  15. YD/T 1199.2-2002 SDH 光发送/光接收模块技术要求 —— SDH 10Gb/s 光发送模块
  16. YD/T 1182-2002 2.5Gb/s DWDM 用特定波长光发射模块技术条件
  17. YD/T 1111.2-2001 SDH 光发送/光接收模块技术要求——2.488320 Gb/s 光发送模块
  18. YD/T 1111.1-2001 SDH 光发送/光接收模块技术要求——2.488320 Gb/s 光接收模块
  19. YD/T 990-1998 交换机与远端模块间专用光传输设备技术条件
  20. YD/T 973-1998 SDH 155Mb/s 和 622Mb/s 光发送模块和光接收模块技术条件
  21. YD/T 1962-2009 具有复用去复用功能的 10Gbit/s 和 40Gbit/s 光收发合一模块软件技?
  22. YD/T 1979.1-2009 不同运营商间3G到2G网络、3G到3G网络漫游技术要求 第1部分: TD-SC
  23. YD/T 2005-2009 用于光纤通道的光收发模块技术条件
  24. YD 5069-1998 移动数据通信网工程设计暂行规定
Thenetwork模块and | 家庭/个人应用 2022-08-29 82 0star收藏 版权: . 保留作者信息 . 禁止商业使用 . 禁止修改作品
家装工程的网络布线其实和电线布线的施工方式法部分相同,都是在地板、墙壁里暗装,通过PVC管和终结在86底盒。但网络线是一个信息点一根网线,中间不允许续接,一线走到底。这些用于一般施工队来说不难,难的是如何安装网线始点和终点的接口模块。在始点是位于家庭信息接入箱中的“网络模块条”的安装,在终点是RJ45信息模块的安装。下面分别讲述:

(The network wiring of the home improvement project is actually the same as the construction method of the wire wiring. They are all concealed in the floor and wall, through the PVC pipe and terminated in the 86 bottom box. But the network cable is an information point and a network cable, and no continuation is allowed in the middle, and one line goes to the end. These are not difficult for general construction teams, but how to install the interface modules at the start and end points of the network cable. The starting point is the installation of the "network module strip" located in the home information access box, and the ending point is the installation of the RJ45 information module. The following are respectively described:)

[下载]12120356467.rar




上一篇:电信IP城域网工程割接实施方案
下一篇:爱立信无源光网络解决方案 江苏电信